Sewing on a Zipper: How to Sew on a Zipper?

How do you sew on a zipper? Sewing on a zipper is one of the important qualities that should be acquired by those who are engaging in sewing as a hobby. A perfectly sewn zipper will give a clean and professional appearance to any sewing you do at home.
Just as in every sewing project, there are important steps in the preparation process before the sewing actually begins. These important steps include marking the zipper’s exact area, aligning the zipper, aligning the stitches so they are straight and equal, starting the sewing in the right place and finishing in the right place.
For some people who view sewing as a hobby, sewing on a zipper is a bit scary because there are different sewing rules to pay attention to according to each zipper type, but it is something that can be easily overcome after you have followed some standard rules.

how-to-sew-on-a-zipper

5 Tips for Properly Sewing on a Zipper

Tip #1:

Buy a longer zipper than you actually need. One of the basic things that make a sewn zipper look bad is the bad stitching marks on the visible side of the zipper when viewed from the front. There are very few things that are more annoying than stitch marks that appear tangled. Especially if you have a sense of symmetry! What creates this problem is that the two ends of the zipper tape usually do not lie comfortably. The ends of the zipper tape drifting off to the right or left can cause the stitch to be skewed.
The solution to this problem is quite simple: buy a zipper that is 5 cm longer than the length that you actually need. This way, when you hold the zipper stretching it from both ends, the position where the sewing will be finished will be flat because it will be a few inches below the edge of the tape. So you can sew the zipper on easily. After the zipper has been sewn on, you can cut the excess section off with scissors.

Tip #2:

Accurate measuring and marking: preparation before sewing is everything! Some zipper sewing methods can seem quite simple. It’s as if we can pick up any zipper we have and sew it on. It’s that simple! Is it really though? Think again. Keeping the zipper on the sewing area and sewing the stitch marks in a straight line is a difficult task even for the most experienced sewer. The secret of success is succeeding in the pre-sewing preparation. There is no doubt that calculating the sewing area with millimetric calculations will make the marking process easier.
Mark the area of the zipper before actually fastening it with a pencil and draw guiding lines. This way, you can easily understand whether or not you are misaligning the zipper when sewing. Remember, in sewing the devil is in the details. With pre-work preparation, you can simplify everything and end up with an excellent job the first go around.

Tip #3:

For perfect accuracy, tack the zipper onto the sewing area. The importance of tacking in the process of sewing on a zipper cannot be underestimated. Above all, it prevents the top fabric from slipping to the left or right, which will ensure that your stitches are completely straight. In this way, the zipper teeth will be precisely aligned on the sewing gap, which will allow the zipper to zip and unzip easily. The biggest advantage is that if things go wrong and the sewing is poor, you will not have to fix everything from scratch. A very important tip is to sew a zipper on once.

Tip #4:

Sew the zippers onto a section as straight as possible. This may not always be possible, but if possible, avoid corner and surface seams. This will ensure your stitches will be easier.

Tip #5:

Gather training resources about sewing on zippers in an agenda. There are countless tutorial sources whether in sewing books or on websites about sewing, and it is impossible not to get lost in this source pool. Gather from what you think are the best; it could be on the computer or in an agenda. In this way, you can go back and look at any moment you need.

2018-02-19T13:52:05+03:00